1. introduction once you have soldered the headers your board is ready to be placed into desired mikrobus? socket. make sure to align the cut in the lower-right part of the board with the markings on the silkscreen at the mikrobus? socket. if all of the pins are aligned correctly, push the board all the way into the socket. 3. plugging the board in 2 3 2. soldering the headers 1 4. essential features turn the board upward again. make sure to align the headers so that they are perpendicular to the board, then solder the pins carefully. turn the board upside down so that bottom side is facing you upwards. place shorter parts of the header pins in both soldering pad locations. thermo click before using your click board?, make sure to solder 1x8 male headers to both left and right side of the board. two 1x8 male headers are included with the board in the package. click board www.mikroe.com thermo click manual ver. 1.00 0 100000 020975 thermo click? is an accessory board in mikrobus ? form factor. its a compact solution for adding thermocouple to your device. it features MAX31855K thermocouple-to-digital converter as well as pcc-smp connector for k-type thermocouple probes. thermo click? communicates with the target board via spi interface (read-only). the board is designed to use 3.3v power supply only. it has a led diode (green) that indicates the presence of power supply. the combination of the MAX31855K and pcc-smp connector results in support for high accuracy temperature measurement. the MAX31855K has a temperature range between -270 and 1372c with sensitivity of about 41v/c. it has a built-in 14-bit adc converter. all these features make this board ideal for thermostatic, process-control, monitoring applications and more.
8. support mikroelektronika ofers free tech support (www.mikroe.com/esupport) until the end of product lifetime, so if something goes wrong, we are ready and willing to help! 7. code examples .com once you have done all the necessary preparations, its time to get your click board up and running. we have provided the examples for mikroc, mikrobasic and mikropascal compilers on our libstock website. just download them and you are ready to start. 5. thermo click? board schematic +3v3 sdo sck r2 2k2 e1 10u f c s # c1 100n f fp1 fe rr it e l d1 pw r 1 2 3 5 4 6 7 8 gn d t - t + vc c sck cs so dnc u 1 max31855 k al- ch+ k cn 1 pcc-sm p +3v3 vc c sdo sck c s # vc c r1 10k vc c an rst cs sck mosi miso +3.3v gn d pwm in t rx t x scl sda +5v gn d m ikr obus device co nn. mikroelektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document. specifcation and information contained in the present schematic are subject to change at any time without notice. copyright ? 2012 mikroelektronika. all rights reserved. 6. thermocouple probe in order to use thermo click? board you need to connect the appropriate k-type thermocouple probe (not included in the package) into the pcc-smp connector, as shown in fgure above.
|
